Carrier fluid bed dryer

Location: Wisconsin, United States

Asking price: $50,000.00 or best offer

Item details

One (1) used Carrier fluid bed dryer as described and shown below.

Table 1: Process Summary:

Product coated frac sand

Design feed rate (see note 1) 20 TPH (40,000 Lb./Hr.)

Design inlet moisture 2% (maximum)

Discharge moisture dry to “free flowing state”

Particle size 14-140 mesh (assumed)

Inlet raw material temperature ambient (design = 70 degrees Fahrenheit)

Material discharge temperature 170-180 degrees Fahrenheit

Drying zone air flow (SCFM) 2920 to 4680 SCFM

Process air temperature up to 500 degrees Fahrenheit

Low fire temperature (for reference) 185 degrees Fahrenheit – 220 degrees Fahrenheit

Set point – master controller 170 degrees Fahrenheit – 180 degrees Fahrenheit (sand temperature)

Set point – slave controller 500 degrees Fahrenheit (drying air temperature)

Exhaust air temperature about 200 degrees Fahrenheit

Vibration frequency about 895 RPM

Vibration stroke 3/16-inch

Drying air high temperature limit set-point 550 degrees Fahrenheit

Exhaust air temperature high temperature limit set-point 275 degrees Fahrenheit

Vibrating exhaust hood pressure negative 0.05 – 0.25 inches WC

Fuel and pressure natural gas x 3,000 CFH @ 3 PSIG minimum – 7 PSIG maximum

Note:

Status: available

Terms: as is where is

Location: Wisconsin, United States

Asking price: $50,000.00 or best offer